Default Mvr Settings - Cisco nexus 5000 series Configuration Manual

Configuring MVR
• MVR configuration on Flex Link ports is not supported.
• Priority tagging is not supported on MVR receiver ports.
• When using private VLANs (PVLANs), you cannot configure a secondary VLAN as the MVR VLAN.
• The total number of MVR VLANs cannot exceed 250.
Note During and in-service software upgrade ( ISSU), MVR IGMP membership for the MVR receiver ports
may timeout because the joins are not forwarded to the upstream router. In order to avoid a timeout, the
querier timer on the upstream router or the network querier should be increased to accommodate an ISSU.

Default MVR Settings

Parameter
MVR
Global MVR VLAN
Interface (per port) default
Configuring MVR
Configuring MVR Global Parameters
SUMMARY STEPS
1. switch# configure terminal
2. switch(config)# [no] mvr
3. switch(config)# [no] mvr-vlan vlan-id
4. switch(config)# [no] mvr-group addr[/mask] [count groups] [vlan vlan-id]
5. (Optional) switch(config)# end
6. (Optional) switch# clear mvr counters [source-ports | receiver-ports]
7. (Optional) switch# show mvr
8. (Optional) switch# copy running-config startup-config
OL-25842-01
Cisco Nexus 5000 Series NX-OS Layer 2 Switching Configuration Guide, Release 5.1(3)N1(1)
Default
Disabled globally and per interface
None configured
Neither a receiver nor a source port
Default MVR Settings
257