Verifying The Interface Configuration - Cisco nexus 5000 series Configuration Manual

Verifying the Interface Configuration

This example shows how to enable 802.1Q tagging on the switch:
switch# configure terminal
switch(config)# vlan dot1q tag native
switch(config)# exit
switch# show vlan dot1q tag native
vlan dot1q native tag is enabled
Verifying the Interface Configuration
Use the following commands to display access and trunk interface configuration information.
Command
switch# show interface
switch# show interface switchport
switch# show interface brief
Cisco Nexus 5000 Series NX-OS Layer 2 Switching Configuration Guide, Release 5.1(3)N1(1)
78
Configuring Access and Trunk Interfaces
Purpose
Displays the interface configuration
Displays information for all Ethernet interfaces,
including access and trunk interfaces.
Displays interface configuration information.
OL-25842-01