Enabling Vpc Auto-Recovery - Cisco nexus 5000 series Configuration Manual

Configuring Virtual Port Channels
Output Queuing (Absolute
Priority)
STP Mode
STP Disabled
STP MST Region Name
STP MST Region Revision
STP MST Region Instance to
VLAN Mapping
STP Loopguard
STP Bridge Assurance
STP Port Type, Edge
BPDUFilter, Edge BPDUGuard
STP MST Simulate PVST
Allowed VLANs
Local suspended VLANs
switch#
This example shows how to check that the required configurations are compatible for an EtherChannel interface:
switch#
Name
-------------
Fex id
STP Port Type
STP Port Guard
STP MST Simulate PVST
mode
Speed
Duplex
Port Mode
Shut Lan
Allowed VLANs

Enabling vPC Auto-Recovery

SUMMARY STEPS
1. switch# configure terminal
2. switch(config)# vpc domain domain-id
3. switch(config-vpc-domain)# auto-recovery reload-delay delay
DETAILED STEPS
Command or Action
Step 1 switch# configure terminal
Step 2 switch(config)# vpc domain domain-id
Step 3
switch(config-vpc-domain)# auto-recovery
reload-delay delay
OL-25842-01
show vpc consistency-parameters interface port-channel 20
Legend:
Type 1 : vPC will be suspended in case of mismatch
Cisco Nexus 5000 Series NX-OS Layer 2 Switching Configuration Guide, Release 5.1(3)N1(1)
2 (F, F, F, F, F, F)
1 Rapid-PVST
1 None
1 ""
1 0
1
1 Disabled
1 Enabled
1 Normal, Disabled,
Disabled
1 Enabled
- 1,624
- 624
Type Local Value
---- ---------------------- -----------------------
1 20
1 Default
1 None
1 Default
1 on
1 10 Gb/s
1 full
1 fex-fabric
1 No
- 1,3-3967,4048-4093
Purpose
Enters global configuration mode.
Enters vpc-domain configuration mode for an existing vPC
domain.
Enables the auto-recovery feature and sets the reload delay
period. The default is disabled.
Enabling vPC Auto-Recovery
(100, 0, 0, 0, 0, 0)
Rapid-PVST
None
""
0
Disabled
Enabled
Normal, Disabled,
Disabled
Enabled
1
-
Peer Value
20
Default
None
Default
on
10 Gb/s
full
fex-fabric
No
1-3967,4048-4093
123