Cisco Nexus 5000 Series Nx-Os Layer 2 Switching Configuration Guide, Release 5.1(3)N1(1 - Cisco nexus 5000 series Configuration Manual

Displaying Interface Information
This example shows how to display the physical Ethernet capabilities:
switch# show interface ethernet 1/1 capabilities
Ethernet1/1
Model:
Type:
Speed:
Duplex:
Trunk encap. type:
Channel:
Broadcast suppression: percentage(0-100)
Flowcontrol:
Rate mode:
QOS scheduling:
CoS rewrite:
ToS rewrite:
SPAN:
UDLD:
Link Debounce:
Link Debounce Time:
MDIX:
FEX Fabric:
This example shows how to display the physical Ethernet transceiver:
switch# show interface ethernet 1/1 transceiver
Ethernet1/1
sfp is present
name is CISCO-EXCELIGHT
part number is SPP5101SR-C1
revision is A
serial number is ECL120901AV
nominal bitrate is 10300 MBits/sec
Link length supported for 50/125mm fiber is 82 m(s)
Link length supported for 62.5/125mm fiber is 26 m(s)
cisco id is --
cisco extended id number is 4
This example shows how to display a brief interface status (some of the output has been removed for brevity):
switch# show interface brief
--------------------------------------------------------------------------------
Ethernet
Interface
--------------------------------------------------------------------------------
Eth1/1
Eth1/2
Eth1/3
Eth1/4
Eth1/5
Eth1/6
Eth1/7
...
This example shows how to display the link debounce status (some of the output has been removed for brevity):
switch# show interface debounce
--------------------------------------------------------------------------------
Port
--------------------------------------------------------------------------------
...
Eth1/1
Eth1/2
Eth1/3
...
This example shows how to display the CDP neighbors:

Cisco Nexus 5000 Series NX-OS Layer 2 Switching Configuration Guide, Release 5.1(3)N1(1)

36
734510033
10Gbase-(unknown)
1000,10000
full
802.1Q
yes
rx-(off/on),tx-(off/on)
none
rx-(6q1t),tx-(1p6q0t)
no
no
yes
yes
yes
yes
no
yes
VLAN Type Mode Status
200 eth trunk up
1 eth trunk up
300 eth access down
300 eth access down
300 eth access down
20 eth access down
300 eth access down
Debounce time Value(ms)
enable 100
enable 100
enable 100
Reason
none
none
SFP not inserted
SFP not inserted
Link not connected
Link not connected
SFP not inserted
Configuring Ethernet Interfaces
Speed Port
Ch #
10G(D) --
10G(D) --
10G(D) --
10G(D) --
1000(D) --
10G(D) --
10G(D) --
OL-25842-01