Jumper And Connector List - Avalue Technology EMX-BSWP User Manual

2.2 Jumper and Connector List

You can configure your board to match the needs of your application by setting jumpers. A
jumper is the simplest kind of electric switch.
It consists of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To "close" a jumper you connect the pins with the clip.
To "open" a jumper you remove the clip. Sometimes a jumper will have three pins, labeled 1,
2, and 3. In this case, you would connect either two pins.
The jumper settings are schematically depicted in this manual as follows:
A pair of needle-nose pliers may be helpful when working with jumpers.
Connectors on the board are linked to external devices such as hard disk drives, a
keyboard, or floppy drives. In addition, the board has a number of jumpers that allow you to
configure your system to suit your application.
If you have any doubts about the best hardware configuration for your application, contact
your local distributor or sales representative before you make any changes.
The following tables list the function of each of the board's jumpers and connectors.
Jumpers
Label
JRI1/2/3/4/5/6
JMSW1
JSBKL1
JSATX1
CMOS1
Connectors
Label
FAN1
FPT1
FPT2
DIMM1/2
Function
Serial port 1/2/3/4/5/6 pin9 signal
select
SATA2/MSATA1 mPCIe slot selector 6 x 2 header, pitch 2.00mm
LVDS Back Light power selection
AT/ATX Power Mode Select
Clear CMOS
Function
CPU fan connector
Miscellaneous setting connector 1
Miscellaneous setting connector 2
204-pin DDR3L DIMM socket
User's Manual
Note
3 x 2 header, pitch 2.00mm
3 x 1 header, pitch 2.54mm
3 x 1 header, pitch 2.54mm
3 x 1 header, pitch 2.00mm
Note
4 x 1 wafer, pitch 2.54mm
5 x 2 header, pitch 2.54 mm
5 x 2 header, pitch 2.54 mm
EMX-BSWP User's Manual 17