Route The Cables - Honeywell AUTOCUBE 8200 User Manual

5. Cut the cable covers to the length needed to cover the cable channels on the
Note: Cut the cable cover for the back side of the pole sightly shorter than the others so that
the camera cable can exit and be connected to the camera.

Route the Cables

By default the cables are routed out of the bottom of the stand. To route the cables
out of the side:
1. Pull up the stand cover - some resistance is normal.
2. Pull the cables up and through the side exit on the pole.
AutoCube 8200 User Guide
pole. Snap into cable channels.
Cable exit
Cable covers
7