Install The Autocube Camera; Mount The Stand - Honeywell AUTOCUBE 8200 User Manual

Hide thumbs Also See for AUTOCUBE 8200:
Table of Contents

Advertisement

Install the AutoCube Camera

Caution: Do not remove the protective foam during installation.
1. Angle the clamp on the top of the pole perpendicular to the pole. Turn the knob
2. Insert the ball of the camera into the clamp. Make sure the Honeywell logo on
3. Turn the knob to tighten the clamp. Be sure it is tight enough so that the
4. Attach the USB cable at the top of the pole to the camera. Secure the cable to
Note: Be sure the camera is horizontal to the measurement area and aimed directly at the
area. No roll and no yaw.
Note: Keep the protective foam on the camera until installation is finished.

Mount the Stand

Recommended 2 person operation.
1. Rotate the stand assembly upright on the mounting surface. Align stand base
Note: If cables exit through the bottom of the pole, pull them through the mounting surface.
8
to loosen the clamp.
the front is right side up. Adjust the camera to the correct angle (A) from the
pole (see
Dimensions
camera will not move.
the camera by tightening the screws by hand.
Knob to tighten
or loosen clamp
to previously drilled holes.
on page 5).
USB cable to
camera
AutoCube 8200 User Guide

Advertisement

Table of Contents
loading

Table of Contents