Table of Contents
Advertisement
3. Follow the instructions on the screen.
Note: If you are not in the right position, the tool will indicate what to do.
4. Keep matching the calibration board with the pattern on the screen until the
5. When complete, the video stops.
30
The pattern on the screen will move. For each position (right, left, up, down, for-
ward, backward), you must try to match the board with the pattern by rotating
(vertical axis) the board then tilting (horizontal axis) the board. This is indicated
on the screen.
Rotate the Board—Vertical Axis
Tilt the Board—Horizontal Axis
progression bar on the bottom of the screen reaches 100%. This takes
approximately 5 minutes.
AutoCube 8200 User Guide
Advertisement
Table of Contents
