Replacing The Thread Cutter Driving Roller - ELNA eXpressive 970 Service Manual

Replacing the Thread Cutter Driving Roller

Pivot pin
Lever unit
Setscrew
Roller shaft
Setscrew
Thread cutter driving roller
1. Remove the spool stand and right cover (see pages 4
and 5).
2. Loosen the setscrew and remove the pivot pin.
Remove the lever unit from the frame.
3. Loosen the setscrew and remove the roller shaft.
Replace the thread cutter driving roller.
4. Insert the 0.05 mm thickness gauge between the lever
unit and thread cutter driving roller.
Tighten the setscrew securely.
5. Attach the lever unit to the frame and insert the pivot
pin. Tighten the setscrew securely.
6. Adjust the position of the dynamic cutter blade (see
page 45).
7. Attach the parts remove in step 1.
43