Table of Contents
Advertisement
z
q
c
t
q
b
u
Figure A
i
q
m
,
t
z x
c
e
x
q
r
w
v
y
n
o
q
e
w
Using a standard thread
z Pass the thread up to the looper thread guide (in front
of the looper threader hole).
q Looper thread
e
x Prepare 12˝ (30 cm) of a standard thread and tie it 5
cm from the end of the looper thread as shown.
w Standard thread
e Knot
r 5 cm
NOTE:
when tying the standard thread to the looper thread,
tie a knot as small as possible and cut any excess
standar thread.
c Set the looper threader switch lever to "THREADING"
position.
t Looper threader switch lever
v Turn the handwheel toward you slowly until it clicks.
This locks handwheel in place.
y Handwheel
b Using the tweezers, insert approximately 1˝ (2 cm) of
the standard thread into the threading hole.
u Tweezers
i Looper threader hole
n Raise the looper threader lever until it clicks into
place.
Lower the looper threader lever until it knocks into
place.
o Looper threader lever
m Pull out approximately 4˝ (10 cm) of the standard
thread from the hole in the looper tip and trim it at the
knot.
* When the knot reaches the looper threader hole,
fold the loose end of the looper thread as illustrated
by figure A in procedure b.
, Return the looper threader switch lever to the
"SEWING" position.
Replacing threaded looper thread
z Cut the threaded looper thread between the thread
guide and the top cover thread guide.
q Thread guide
w Top cover thread guide
x Set a new spool of looper thread.
Pass the new looper thread through the thread guide,
and tie it to the end of the threaded looper thread.
Tie a knot as small as possible.
e Knot
c Slowly pull the threaded looper thread out from the
hole of the looper tip until the knot comes out.
27
Advertisement
Table of Contents
