Thread Cutter - ELNA eXcellence 780 Service Manual

Thread cutter

The distance between the end of thread cutter plate slit and the end of moving cutter should be in the range of 0.4 to
1.2 mm.
End of thread cutter plate slit
End of moving cutter
0.4 to 1.2 mm
A
B
Setscrew
Sensor plate
Mechanical adjustment
Moving cutter
33
To check:
1. Remove the bed cover and free arm cover (see pages
3-4).
2. Turn the power switch ON.
The moving cutter motor is initialized, and moving
cutter moves to its home position automatically.
3. The distance between the end of moving cutter and
the end of thread cutter plate slit should be 0.4 to 1.2
mm.
If not, adjust it as follows.
To adjust:
1. Turn the power switch OFF. Loosen the setscrew on
the sensor plate.
2. If the distance is smaller than 0.4 mm, move the
sensor plate in the direction of A.
If the distance is larger than 1.2 mm, move the sensor
plate in the direction of B.
3. Turn the power switch ON to initialize the cutter
position and check if the distance is within 0.4 to 1.2
mm.
4. Attach the bed cover and free arm cover.