Adjusting The Moving Head Stop Position - ELNA eXpressive 970 Service Manual

Adjusting the Moving Head Stop Position

Setscrew
1. Remove the spool stand, right cover, left cover and
tension control panel (see pages 4 – 6).
2. Open the factory adjusting menu window and press
the Needle key to open the Needle Change adjusting
window.
3. Turn the lateral movement idler gear to set the lateral
Lateral
movement cam at the middle of the flat portion.
movement
The indication next to NCHM Init Sen should be "H".
idler gear
To adjust the stop position, loosen the setscrew and
turn the stop positioning shield plate.
Tighten the setscrew.
NOTE:
The shield plate should not interfere with the sensor.
4. Press Init key to move the head to the stop position
and check if "L" is indicated.
5. Attach the parts removed in step 1.
Stop position
shield plate
Phase reference of the
lateral movement cam and
stop position shield plate
61