Reconfiguration Steps For Boot Block Version 1.01 Or Earlier - Cisco Aironet 340 Series Hardware Installation Manual

Resetting to the Default Configuration

Reconfiguration Steps for Boot Block Version 1.01 or Earlier

Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Cisco Aironet Access Point Hardware Installation Guide
4-6
Follow these steps to reconfigure your Access Point if the boot block version on
your Access Point is version 1.01 or earlier. To find which boot block version is
on your Access Point, follow the steps in the "Determining the Boot-Block
Version" section on page 4-5.
Use a straight-through cable with 9-pin male to 9-pin female connectors to
connect the COM 1 or COM 2 port on your computer to the RS-232 port on the
Access Point.
Open a terminal-emulation program on your computer.
Note These instructions describe HyperTeminal; other programs
are similar.
In the Connection Description window, enter a name and select an icon for the
connection and click OK.
In the Connect To window, select the port to which the cable is connected and
click OK.
In the Port Settings window, make the following settings: 9600 baud, 8 data bits,
No parity, 1 stop bit, and Xon/Xoff flow control.
Click OK and press Enter three times.
When the Summary Status screen appears, reboot the Access Point by
unplugging the power connector and then plugging it back in, or by pressing
Ctrl-X.
When the message "Type <esc> within 5 seconds for menu" appears, press Esc.
Copy the Access Point's installation key to the Access Point's DRAM by
pressing c to select Copy file, then 1 to select DRAM, then the selection letter
for the AP Installation Key.
Chapter 4 Troubleshooting
OL-0738-01