Determining The Boot-Block Version - Cisco Aironet 340 Series Hardware Installation Manual

Chapter 4 Troubleshooting

Determining the Boot-Block Version

Step 1
Step 2
Step 3
Step 4
Step 5
OL-0738-01
The steps you follow to reconfigure the Access Point depend on the version of the
Access Point's boot block. Follow these steps to find out which boot block version
is on your Access Point.
Open a Telnet session to the Access Point.
Note You can also use these instructions while communicating
with the Access Point through the console port or with an
SNMP manager. Skip to Step 3 if you use an SNMP
manager.
Type :cmd and press Enter to switch from text-browser mode to SNMP mode.
Type bootblockVersion and press Enter. Text appears with information about the
system. If your Access Point's boot block version is 1.01, the text might look like
this:
OID: iso.org.dod.internet.private.enterprises.aironet.awcVx.awcSystem.
bootblockVersion
Value [RO]: 1.01
Type exit and press Enter to return to text-browser mode.
If your boot block version is 1.01 or earlier, follow the instructions in the
"Reconfiguration Steps for Boot Block Version 1.01 or Earlier" section on
page 4-6. If your boot block version is 1.02 or later, follow the instructions in the
"Reconfiguration Steps for Boot Block Version 1.02 or Later" section on
page 4-7.
Cisco Aironet Access Point Hardware Installation Guide
Resetting to the Default Configuration
4-5