Cisco Aironet 340 Series Hardware Installation Manual page 60

Resetting to the Default Configuration
Note
Step 3 In the Connection Description window, enter a name and select an icon for the
connection and click OK.
In the Connect To window, select the port to which the cable is connected and
Step 4
click OK.
Step 5 In the Port Settings window, make the following settings: 9600 baud, 8 data bits,
No parity, 1 stop bit, and Xon/Xoff flow control.
Step 6 Click OK and press Enter.
When the Summary Status screen appears, reboot the Access Point by pressing
Step 7
Ctrl-X or by unplugging the power connector and then plugging it back in.
When the memory files are listed under the heading "Memory:File," press
Step 8
Ctrl-W within 5 seconds to reach the boot block menu.
Copy the Access Point's installation key to the Access Point's DRAM by
Step 9
pressing c to select Copy file, then 1 to select DRAM, then the selection letter
for the AP Installation Key.
Note
Reformat the Access Point's configuration memory bank by pressing Ctrl-Z to
Step 10
reach the reformat menu. When the menu appears, press ! to select FORMAT
memory bank, then 2 to select Config, then upper-case Y to confirm the
FORMAT command.
Copy the installation key back to the configuration memory bank by pressing c
Step 11
to select Copy file, then 2 to select Config, then the selection letter for the AP
Installation Key.
Cisco Aironet Access Point Hardware Installation Guide
4-8
These instructions describe HyperTeminal; other programs
are similar.
If the list of configuration files contains a file called VAR
Installation Key, you need to copy that file to DRAM along
with the installation key. Copy the VAR installation key to
DRAM by pressing c to select Copy file, then 1 to select
DRAM, then the selection letter for the VAR installation
key.
Chapter 4 Troubleshooting
OL-0738-01