Cisco Aironet 340 Series Hardware Installation Manual page 48

Entering Basic Settings
Figure 3-1
Open a terminal emulator.
Step 2
Enter these settings for the connection:
Step 3
Step 4 Press = to display the home page of the Access Point. If the Access Point is new
and its factory configuration has not been changed, the Express Setup page
appears; if the Access Point has been configured, the Summary Status page
appears.
Step 5 Press n to select System Name. Type a system name for the Access Point and press
Enter. A descriptive system name makes it easy to identify the Access Point on
your network.
Press t and then press Enter to select Terminal Type. Press t and then press Enter
Step 6
to select teletype display on the console interface. Press a and then press Enter to
select ANSI display on the console interface.
Step 7 Press pr and then press Enter to select Config Server Protocol. Press n to select
none; press b to select BOOTP; press d to select DHCP. Press Enter after you
make your selection.
Cisco Aironet Access Point Hardware Installation Guide
3-10
Connecting the Serial Cable
5 V D C
S E R IA L
RS-232
9-pin serial extension
cable to PC COM port
Bits per second (baud rate): 9600
•
Data bits: 8
•
• Parity: none
Stop bits: 1
•
Flow control: Xon/Xoff
•
Chapter 3
S E R IA L
E T H E R N
E T
Basic Configuration
OL-0738-01