Manufacturers Federal Communication Commission Declaration Of Conformity Statement - Cisco Aironet 340 Series Hardware Installation Manual

Manufacturers Federal Communication Commission Declaration of Conformity Statement

Manufacturers Federal Communication Commission
Declaration of Conformity Statement
Models:
AIR-AP340, AIR-AP341, AIR-AP342, AIR-AP351,
AIR-AP352
FCC Certification number:
Manufacturer:
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
Cisco Aironet Access Point Hardware Installation Guide
B-2
LDK102038 (AIR-AP34x),
LDK102040 (AIR-AP35x)
This device complies with Part 15 rules. Operation is subject to the following two
conditions:
This device may not cause harmful interference, and
1.
This device must accept any interference received, including interference that
2.
may cause undesired operation.
This equipment has been tested and found to comply with the limits of a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a residential environment. This equipment generates, uses, and
radiates radio frequency energy, and if not installed and used in accordance with
the instructions, may cause harmful interference. However, there is no guarantee
that interference will not occur. If this equipment does cause interference to radio
or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to correct the interference by one of the following
measures:
Reorient or relocate the receiving antenna.
•
• Increase separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician.
•
Appendix B Declarations of Conformity and Regulatory Information
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE
OL-0738-01