Advertisement
c) Adjusting the electronic brake
Use the „BRAKE SPEED +/-" slide control to set the time the drive is to take to stop the drive.
d) Adjusting the range of the pick-up arm lift
Use the screw on top of the pick-up arm lift to set the lifting/lowering range of the pick-up arm lift for lift-
ing/lowering the pick-up arm when using the corresponding lever of the pick-up arm lift.
• Turn the screw counterclockwise:
• Turn the screw clockwise:
e) Switching the output level; using the digital output
Use the „PHONO/LINE" key to switch between the two different output levels:
Position"PHONO":
Connection to mixer console/amplifier with PHONO input
Position „LINE":
Connection to mixer console/amplifier with LINE input
The digital output („DIGITAL OUT") is only activated if the switch is in the position „LINE"!
f) Reversing the turntable's direction of rotation
Use the „REVERSE" key to reverse the direction of rotation of the turntable.
The LED next to the key is on, if the direction of rotation has been reversed (is „wrong"); the
LED is off, if the direction of rotation is the standard direction.
g) Using the lighting „TARGET LIGHT"
Use the „TARGET LIGHT" key to switch on the lighting of the target point. The target light ensures that you
see the point at which the diamond of the needle touches the record.
Pressing of the small key unlocks the light which is then extended and switched on.
To switch off the light just press it down until it clicks into place.
h) „REMOTE START/STOP" input
This socket (3.5mm mono socket) on the back of the record player may e.g. be connected to a suitable mix-
er console. Each short connection of the two contacts alternatingly starts and stops the turntable drive
(Start > Stop > Start > Stop ....).
34
increase the range
decrease the range
b) Rear (connections)
DIGITAL
R
L
PHONO LINE
OUT
23
24
25
23
cinch sockets „L/R"
For connection to the amplifier
24
selector switch „PHONO/LINE"
For switching the output level
25
socket „DIGITAL OUT"
Socket for digital output
26
socket „REMOTE START/STOP"
3.5mm socket (mono) for external
turntable control (start/stop)
27
Mains cable
For connection to the mains voltage (230V~/50Hz)
REMOTE
START/STOP
26
27
27
Advertisement
Chapters
