Mitel SX-200 ICP Technician's Handbook page 198

SX-200 ICP CX/CXi Technician's Handbook
4. Run SX200ICP_SETUP.EXE from the CD.
5. Select Local Upgrade [Flash Card] Installation, then click Next.
6. Select languages for voice mail prompts if applicable. The default is
English and is not selectable.
7. Select the CompactFlash Reader/Writer drive.
8. Select Format to format the CompactFlash card, then click Next.
Note: When formatting the CompactFlash card, select FAT as the file system.
9. Click Finish when prompted.
10. Wait until the computer completes writing to the CompactFlash card
before ejecting it.
Note: To avoid ending the writing operation before it finishes, DO NOT click
STOP prior to EJECT.
11. Remove the CompactFlash card from the Reader/Writer and insert it
into the card slot on the front of the controller.
12. Log into the Maintenance Terminal and begin a Maintenance session.
13. Press
SYSTEM
RE_START
RESET_SYSTEM
The system boots from the CompactFlash card and installs the new
software. Installation is complete when the phones are up and the LED
next to the card slot turns green.
14. When prompted, log into the Maintenance Terminal in CDE mode and
program all the purchased options from the MOSS sheet. (This step is
not usually required for a software upgrade.)
15. Remove the external CompactFlash card when the LED adjacent to
the card slot turns green.
190