Installing The Batteries To The Remote; Connect Power & Antenna/Cable; Switching On/Off; To Switch The Tv Off - Luxor LED19EL Operating Instructions Manual

Installing the Batteries to the Remote

1. Lift the cover on the back of the remote upward
gently.
2. Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3. Replace the cover.
Connect Power & Antenna/Cable
IMPORTANT: The TV set is designed to operate on
12 V DC. For this, an adaptor is used which gives 12 V
voltage. Connect this adaptor to a system that supplies
110-240V AC, 50/60Hz.After unpacking, allow the TV
set to reach the ambient room temperature before you
connect the set to the mains.
12V
VGA
SPDIF
To POWER
INPUT DC 12 V
terminal
AC adapter

Switching On/Off

To Switch the TV On
Connect the power cord to the 110-240V AC,
50/60Hz.
To switch on the TV from standby mode either:
" button, P+ / P- or a numeric button on
Press the "
the remote control.
Press the control switch located on the left side
of the TV. The TV will then switch on.
Aerial or Cable
12V
VGA
SPDIF
English - 41 -

To Switch the TV Off

Press the " " button on the remote control
or press and hold the control switch on the TV
until the TV shuts down, so the TV will switch to
standby model (Depends on the model).
To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode, standby
LED can blink to indicate that features such as Standby
Search, Over Air Download or Timer is active. The LED can
also blink when you switch on the TV from standby mode.

First Time Installation

When turned on for the first time, the "language
selection" menu appears. The message "Welcome
please select your language!" is displayed in all
language options listed alphabetically.
Press the " " or "
language, press OK button to select. "First Time
Installation" appears. Use "
required country, and press "
Type. Use " " or "
Available search types are Digital and analog, digital
only and analog only. When set, press "
Teletext Language. Use "
"Teletext Language" and select "Scan Encrypted" using
" " or " " button. You can set Scan Encrypted as
Yes if you want to scan coded stations.
Deafult PIN code can change depending on the
selected country.
If you are asked to enter a PIN code for viewing a
menu option, use one of the following codes: 4725,
0000 or 1234.
" button to highlight the required
" or " " button to set the
" button to select Search
" to set the desired search type.
" to select
" or " " button to set the