Dvd - Control Buttons; Inserting The Batteries Into The Remote; Connect Power; Antenna/Cable Connection - Luxor LED24EL Operating Instructions Manual

through the available sources by pushing the button
up or down.
To turn the TV off: Press the middle of the button
down and hold it down for a few seconds, the TV will
turn into standby mode.

DVD - Control buttons

1. Play / Pause (
Plays / pauses the disc. When DVD menu (root
menu) is active, this button functions as "button
select" (selects the highlighted item in menu) if
this is not prohibited by the disc).
2. Stop / Eject ( /
Stops the disc playing / Ejects or Loads the
disc.
3. Disc loader
NOTE: You cannot eject the disc via the remote control.
To eject while playing a file; you should press the STOP button
" / " (on the TV) three times.
/ ) button
) button

Inserting the Batteries into the Remote

Lift the cover on the back of the remote upward
gently. Install two AAA batteries. Make sure to
match the + and - ends of the batteries in the
battery compartment (observe the correct polarity)
Replace the cover.

Connect Power

IMPORTANT: The TV set is designed to operate on
12 V DC. For this, an adaptor is used which gives 12 V
voltage. Connect this adaptor to a system that supplies
110-240V AC, 50/60Hz.After unpacking, allow the TV
set to reach the ambient room temperature before you
connect the set to the mains.

Antenna/Cable Connection

Connect the "aerial" or "cable TV" plug to AERIAL
INPUT (ANT) socket located on the back of the TV.

Notification

Manufactured under license from Dolby Laboratories.
TRADEMARK ACKNOWLEDGMENT
"Dolby" and the double-D symbol are trademarks of
Dolby Laboratories.
1
2
"HDMI, the HDMI logo and High-Definition Multimedia
Interface are trademarks or registered trademarks of
HDMI Licensing LLC."
3
English - 48 -