Installing The Batteries To The Remote; Connect Power & Antenna/Cable; Switching On/Off; First Time Installation - Luxor led50rz Operating Instructions Manual

Installing the Batteries to the Remote

1. Lift the cover on the back of the remote upward
gently.
2. Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3. Replace the cover.
Connect Power & Antenna/Cable
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.

Switching On/Off

To Switch the TV On
Connect the power cord to the 220-240V AC, 50Hz.
To switch on the TV from standby mode either:
Press the "
the remote control.
Press the control switch located on the left side
of the TV. The TV will then switch on.
To Switch the TV Off
Press the "
or press and hold the control switch on the TV
until the TV shuts down, so the TV will switch to
standby model (Depends on the model).
To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode, standby
LED can blink to indicate that features such as Standby
Search, Over Air Download or Timer is active. The LED can
also blink when you switch on the TV from standby mode.

First Time Installation

When turned on for the first time, the "language
selection" menu appears. The message "Welcome
Aerial or Cable
please select your language!" is displayed in all
language options listed alphabetically.
Press the "
language, press OK button to select. "First Time
Installation" appears. Use "
required country, and press "
Type. Use "
Available search types are Digital and analog, digital
only and analog only. When set, press "
Teletext Language. Use "
"Teletext Language" and select "Scan Encrypted" using
" " or "
Yes if you want to scan coded stations.
English - 32 -
" button, P+ / P- or a numeric button on
" button on the remote control
" or " " button to highlight the required
" or "
" button to select Search
" or " " to set the desired search type.
" or "
" button. You can set Scan Encrypted as
" button to set the
" to select
" button to set the