Okuma OSP-P200L Programming Manual page 78

•
If the same point as in the start-up block is specified in the succeeding block, an alarm will result
if the successive two blocks after that do not have dimension words, X and Z.
Faulty program example 1:
N1 G01 X50 Z100 F0.2
N2 G42
N3 X50 Z100
N4 X60 Z80
N5 X100 Z50
Since sequence N3 designates a point identical to the one designated in the start-up sequence
N2, an alarm occurs.
Faulty program example 2:
N1 G01 X50 Z100 F0.2
N2 G42
N3
N4
N5 X50 Z100
N6 X60 Z80
Since sequences N3 and N4, the successive two sequences after the start-up of the tool nose
radius compensation mode, do not contain X and Z axis movement commands, an alarm
occurs.
S1000 T010101 M3
S500 T010101 M3
S1000
M08
SECTION 6 OFFSET FUNCTION
LE33013R0300800090006
LE33013R0300800090007
5238-E P-65