Table of Contents
Advertisement
SECTION 9 CONTOUR GENERATION
1.
Contour Generation Programming Function (Face)
1-1.
Function Overview
The contour generation function can cut straight lines or arcs on the end face of a workpiece by
simultaneous two-axis interpolation of the C- and X-axes on multi-machining models.
Note that simultaneous three-axis control of X, Z, and C axes is possible for straight line cutting on a
plane.
1-2.
Programming Format
Straight line cutting : G101 X Z C F
Arc cutting
X, Z, C : Coordinates of target point on straight line
F :
Feedrate (mm/min)
: G102 X C L F
X, C :
Coordinates of end point of clockwise arc
L :
Arc radius
F :
Feedrate (mm/min)
: G103 X C L F
X, C :
Coordinates of end point of counterclockwise arc
L :
Arc radius
F :
Feedrate (mm/min)
SECTION 9 CONTOUR GENERATION
5238-E P-235
Advertisement
Table of Contents
