Table of Contents
Advertisement
2.
PSELECT Block
[Function]
A PSELECT block selects and executes main programs for a workpiece to be machined.
•
This function searches a specified main program file for a specified main program to be
selected as a machining program. The function also searches a specified subprogram file, or
system subprogram file, and manufacturer subprogram file for the required subprograms and
selects them automatically.
•
It repeats selected programs as specified.
[Programming format]
The commands must be specified in the following order:
Commands enclosed by [ ] may be omitted. Note that a comma "," may also be omitted if the items
that follow are all omitted.
{PSELECT}
fm: Main program file name
[
3 characters
Device name
•
If a device name, a file name, and/or an extension is omitted, entries of "MD1", "A", and "MIN",
respectively, are assumed to apply. If all entries for "fm" are omitted, "MD1:A.MIN" is assumed
to apply.
•
An alarm will occur if "*" or "?" is used in a main program file name.
•
An alarm will occur if the specified file does not exist.
pm: Main program name
0
Within 5 characters
•
If entry of "pm" is omitted, the program name of the first program in the specified main program
file is assumed to apply.
•
An alarm will occur if the specified program does not exist in the selected main program file, fm.
•
An alarm will occur if M02 or M30, indicating the end of the program, is not specified in the
specified main program.
[fm],[pm],[fs],[n](CR) or (LF)
Entries enclosed by [ ] may be omitted.
:] [
Within 16 characters
File name
SECTION 13 SCHEDULE PROGRAMS
] [.
]
3 characters
Extension
5238-E P-316
LE33013R0301500020001
LE33013R0301500020002
LE33013R0301500020003
Advertisement
Table of Contents
