Example Program For Longitudinal Grooving Compound Fixed Cycle (G73) - Okuma OSP-P200L Programming Manual

T : Tool offset number determining the tool offset amount when target point on the Z-axis is
reached.
(If no T word is specified, the tool offset number selected on positioning to the starting point
of the grooving cycle is selected. The T command after this block is the one designated when
positioning to the starting point is performed.)
6-2. Example Program for Longitudinal Grooving Compound Fixed
Cycle (G73)
210
300
N0001 G00
N0002
N0003 G73
* : (Z-axis tool offset amount of #2) - (Z-axis tool offset amount of #1) = 20
T0102
20
X1000 Z1000 S300
X240 Z300
X110 Z210 I45
T0101
T0101 M03 M42
K18 D20 E0.2
5238-E P-127
SECTION 7 FIXED CYCLES
F0.3 T0102
LE33013R0300900200001