Okuma OSP-P200L Programming Manual page 291

Hide thumbs Also See for OSP-P200L:
Table of Contents

Advertisement

Zero offset variables
VZOFZ
VZOFX
VZOFC
Set variables in the following manner: VZOFZ = 12364.256.
Zero shift variables
VZSHZ
VZSHX
VZSHC
Set variables in the following manner: VZSHZ = 50.
These zero shift variables deal with shift amount set by the zero shift operation called by G50, and
the set shift amount is cleared when the control is reset.
Tool offset variables
VTOFZ [Tool Offset No.]
VTOFX [Tool Offset No.]
Set variables in the following manner: VTOFZ [5] = 2.634.
This indicates that tool offset amount of the Z-axis for #5 is set 2.634.
Nose radius compensation variables
VNSRZ [Nose R Compensation No.]
VNSRX [Nose R Compensation No.]
Set variables in the following manner: VNSRZ [4] = 0.8
This indicates that the nose radius (on the Z-axis) of the tool assigned nose radius compensation
no. 4 is set to 0.8 mm.
........
Zero OFfset of Z-axis
Zero OFf set Z-axis
........
Zero OFfset of X-axis
........
Zero OFfset of C-axis (for multi-machining model)
........
Zero SHift of Z-axis
Zero SHift Z-axis
........
Zero SHift of X-axis
........
Zero SHift of C-axis (for multi-machining model)
........
Tool OFfset of Z-axis
Tool OFfset Z-axis
........
Tool OFfset of X-axis
........
NoSe Radius compensation of Z-axis
NoSe Radius Z-axis
........
NoSe Radius compensation of X-axis
5238-E P-278
SECTION 12 USER TASK
LE33013R0301400140001
LE33013R0301400150001
LE33013R0301400160001
LE33013R0301400170001

Advertisement

Table of Contents
loading

This manual is also suitable for:

Osp-p20l-rOsp-p20lOsp-p200l-r

Table of Contents