Operation Time Reduction Function - Okuma OSP-P200L Programming Manual

3.

Operation Time Reduction Function

Refer to the Operation Manual for details of the operation time reducing function II.
4. Turret Unclamp Command (for NC Turret Specification)
The NC simultaneously unclamps the turret and causes axis travel on receiving the M203
command. This command is effective only when it is specified with G00 in the same block.
Example:
G01 X200
G00 X220
G00 X500
X220
Note that if the M203 command is specified in the same block as G00 it unclamps the turret without
regard to the present turret position.
If the M203 command is preceded by a cutting feed command (feed command other than G00) and
the turret clamped condition is not confirmed, the alarm "A1730 Turret clamp or position code 3" will
occur.
Z300
Z800 M203
Z300 T020202
SECTION 14 OTHER FUNCTIONS
Simultaneous movements of X-
X220 X500
axis from 220 to 500 and Z-axis
Z300 Z800
from 300 to 800.
5238-E P-326
LE33013R0301600070001