Okuma OSP-P200L Programming Manual page 362

Variables
VSKFA Gauging feedrate 2
VSKFB Gauging feedrate 1
VCHKL Chuck jaw dimension L1
VCHKD Chuck jaw dimension D1
VCHKZ Chuck jaw position CZ
VCHKX Chuck jaw position CX
VTSL Tailstock spindle projection L2
VTSDA Tailstock spindle diameter D2
VTSDB Tailstock center diameter D3
VWKR Workpiece end face WR
VRZV Robot point data Z-axis
VRCV Robot point data C-axis
VRRG Robot register data
VLZV Loader point data Z-axis
VLYV Loader point data Y-axis
VLRG Loader register data
VPLOF M-axis zero offset for flat turning
VRYV Robot point data Y-axis
VRBV Robot point data B-axis
VRWV Robot point data W-axis
VRXV Robot point data X-axis
VTLMT Tool type number
VMXA1 MAX in tool nose form code table A1
VMNA1 MIN in tool nose form code table A1
VMXA2 MAX in tool nose form code table A2
VMNA2 MIN in tool nose form code table A2
VCHIO Chuck ID grip/OD grip changeover data
VCHSW Chuck work/between-centers work changeover data
VZARP Designated ZA-axis position
VZBRP Designated ZB-axis position
VZCRP Designated ZC-axis position
VXARP Designated XA-axis position
VXBRP Designated XB-axis position
VWAP Designated W-axis position
Dislocation between the sensor center and the sensor
VSNWD
head in the C-axis forward rotation
Dislocation between the sensor center and the sensor
VSNTU
head in the C-axis reverse rotation
VRUND 360 constant
VUNIT Unit system
*: System variables are not available depending on machine specifications.
Contents
5238-E P-349
SECTION 15 APPENDIX
Setting Range
1 to 500
0 to 9999.999
0 to ±9999.999
0 to 9999.999
0 to ±9999.999
0 to 99999999
0 to ±32767
0 to ±99999999
0 to ±32767
0 to 359.999
0 to ±99999999
0 to 80
I = 1 to 38
0 to 360.000
J = 1 to 4
0 to ±360.000
0, 1
0 to 99999999
READ ONLY
-
0 to 7
Suffix
None
1 to 99
1 to 47
1 to 99
None
1 to 99
K= 1 to 6
None