Table of Contents
Advertisement
[Supplement]
•
Variables are set in block N1000.
•
The Z coordinate of point "a" is commanded in block N1001.
•
The X and Z coordinates of point "b" and arc radius are commanded in block N1002.
•
The X and Z coordinates of point "c" are commanded in block N1003.
•
RTS in block N1004 indicates the end of the subprogram.
[Supplement]
The subprogram ORT01 is called for by the command in block N109 to define the contour
consisting of a circular arc and taper. The variables used for defining this contour are all set in this
block.
Program Example 3 (Cutting a contour consisting of a repetitive contour)
This is an example of programming for a part that has repetitions of the same contour, such as a
pulley.
12
20
A
Programming zero
PC11
ZW2
ZW1
104
20
20
20
1R
16
4.7
[Fig. 3-1]
Tool offset applies at this point
T030303
T030313
TW1
[Fig. 3-2]
SECTION 12 USER TASK
12
5238-E P-311
LE33013R0301400490012
Advertisement
Table of Contents
