Drilling Depth Setting (Only For Drilling Cycles) - Okuma OSP-P200L Programming Manual

Cycle start point
With L command
E

8-18. Drilling Depth Setting (Only for drilling cycles)

For the drilling cycles called by G178, G179, G181, G182, G183, G184, and G189, the drill hole
depth may be specified by an R command (see below) from the position shifted to by I or K, instead
of specifying the end point of the drilling cycles.
±R : Drilling hole depth in drilling cycleIn a drilling cycle, the drill hole depth (distance) is specified
by an R command.
The R command in the X-axis direction must be specified as a diameter.
The use of an R command allows the drilling cycle to be programmed by reference to the hole
depth instead of the end point of the cycle.
When using an R command in a fixed cycle program, program a block of commands like that shown
below.
N102 G 94
N103 G181
(60, 75) (60, 102)
Q
3
Q
4
I/2
I/2
D/2 D/2
D/2 L/2 D/2
α/2
α/2
α/2
L/2
α/2
Without L command
When L is programmed as 0,
an alarm results.
X200 Z150
X 60 R - 27
(200, 150)
Q
1
Q
2
(60, 150)
Cycle start point
T0101 SB=400
C0 K48 F40
5238-E P-157
SECTION 7 FIXED CYCLES
LE33013R0300900470002
LE33013R0300900480001
LE33013R0300900480002