Electrical Requirements; Recommended Grounding Method - Kenmore 596.7931 SERIES Use & Care Manual

2. Create a service loop with the copper tubing. Avoid kinks when coiling
the copper tubing. Secure copper tubing to refrigerator cabinet with a
"P" clamp.
A
A. Copper tubing C. Compression nut
B. "P"clamp D. Compression sleeve
3. Turn on water supply to refrigerator and check for leaks. Correct any
leaks.
Style
2
1. Create a service loop (minimum diameter of 2 ft [61 cm]) with the
copper tubing. Avoid kinks when coiling the copper tubing.
2. Remove the plastic cap from water valve inlet port. Place a
compression nut and sleeve on the copper tubing.
3. Insert the end of the copper tubing into the water valve inlet port.
Shape tubing slightly so that the tubing feeds straight into the port to
avoid kinks.
4. Slide the compression nut over the sleeve and screw into the water
valve inlet port.
/
i
t
..........A
_ B
........D
A. Plastic water tubing
B. Sleeve
C. Compression nut
D. Copper tubing
5.
Using an adjustable wrench, hold the nut on the plastic water line to
keep it from moving. Then, with a second wrench turn the compression
nut on the copper tubing counterclockwise to completely tighten. Do
not overtighten.
i
....... O
A. "P" clamp C. Compression nut
B. Plastic water line D. Copper tubing
6. Check connection by pulling on copper tubing. Attach the plastic
water line to the refrigerator cabinet with a "P" clamp.
Z Turn on water supply to the refrigerator and check for leaks. Correct
any leaks.
}_e_<_" <x;_ R _,_ _,_}<_ +_/:'__ _ _}_
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your refrigerator into its final location, it is important to
make sure you have the proper electrical connection.
Recommended Grounding Method
A 115 volt, 60 Hz, AC only 15- or 20-amp fused, grounded electrical supply
is required. It is recommended that a separate circuit serving only your
refrigerator be provided. Use an outlet that cannot be turned off by a
switch. Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning, or removing a
light bulb, turn the refrigerator to OFF. Depending on your model, either
turn the freezer control to the word OFF, or press the Minus sign touch
pads repeatedly until a dash (-) appears in both the Freezer and
Refrigerator displays as shown. Disconnect the refrigerator from the
electrical source. When you are finished, reconnect the refrigerator to the
electrical source and reset the temperature controls to the desired setting.
See "Using the Controls."
Electronic Dual Control
Freezer Scroll Down for Cooling Off Refrigerator
• is the coldest recommended setting 4 • is the coldest