GE F60 Instruction Manual page 105

Ur series
Hide thumbs Also See for F60:
Table of Contents

Advertisement

5 SETTINGS
The menu for the binary input points (DNP) or MSP points (IEC 60870-5-104) is shown below.
PATH: SETTINGS
PRODUCT SETUP
BINARY INPUT / MSP
POINTS
MESSAGE
MESSAGE
Up to 256 binary input points can be configured for the DNP or IEC 60870-5-104 protocols. The points are configured by
assigning an appropriate FlexLogic™ operand. Refer to the Introduction to FlexLogic™ section in this chapter for the full
range of assignable operands.
The menu for the analog input points (DNP) or MME points (IEC 60870-5-104) is shown below.
PATH: SETTINGS
PRODUCT SETUP
ANALOG INPUT / MME
POINTS
MESSAGE
MESSAGE
Up to 256 analog input points can be configured for the DNP or IEC 60870-5-104 protocols. The analog point list is config-
ured by assigning an appropriate FlexAnalog parameter to each point. Refer to Appendix A: FlexAnalog Parameters for the
full range of assignable parameters.
The DNP / IEC 60870-5-104 point lists always begin with point 0 and end at the first "Off" value. Since DNP /
IEC 60870-5-104 point lists must be in one continuous block, any points assigned after the first "Off" point
are ignored.
NOTE
Changes to the DNP / IEC 60870-5-104 point lists will not take effect until the F60 is restarted.
NOTE
g) IEC 61850 PROTOCOL
PATH: SETTINGS
PRODUCT SETUP
GSSE / GOOSE
CONFIGURATION
MESSAGE
MESSAGE
MESSAGE
MESSAGE
GE Multilin
COMMUNICATIONS
DNP / IEC104 POINT LISTS
Point:
0
Off
Point:
1
Off
Point:
255
Off
COMMUNICATIONS
DNP / IEC104 POINT LISTS
Point:
0
Off
Point:
1
Off
Point:
255
Off
COMMUNICATIONS
IEC 61850 PROTOCOL
REMOTE I/O TRANSFER
METHOD: GSSE
DEFAULT GSSE/GOOSE:
UPDATE TIME: 60 s
GOOSE TRANSMIT VLAN
PRIORITY: 4
GOOSE TRANSMIT VLAN
ID:
0
GOOSE TRANSMIT
ETYPE APPID:
0
F60 Feeder Management Relay
5.2 PRODUCT SETUP
BINARY INPUT / MSP POINTS
Range: FlexLogic™ operand
Range: FlexLogic™ operand
Range: FlexLogic™ operand
ANALOG INPUT / MME POINTS
Range: any FlexAnalog parameter
Range: any FlexAnalog parameter
Range: any FlexAnalog parameter
GSSE / GOOSE CONFIGURATION
Range: None, GSSE, GOOSE
Range: 1 to 60 s in steps of 1
Range: 0 to 7 in steps of 1
Range: 0 to 4095 in steps of 1
Range: 0 to 16383 in steps of 1
5
5-17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents