Table of Contents
Advertisement
3.7
AUTO-ANSWER FEATURE
To program the auto-answer feature locate the 660-650 Printed Circuit
Board under the large (660-000) main printed circuit board. Refer to the
diagram on page 20 of this manual. Move the mini-jumper to the
desired ring count, from 1-9.
When in operation, the telephone may be called from a remote location
and it will automatically answer itself after the number of rings, as
selected above. The telephone comes from the factory set to answer after
one ring, but this may be adjusted as stated above.
NOTE: The telephone may be manually answered any time prior to the
activation of the auto-answer feature, at which time conversation may take
place. Example: if the phone is set to auto-answer after nine rings, a
person at the telephone may answer on rings 1-8.
conversation could take place.
The Auto-Answer feature MUST be activated in order to utilize the
Remote Programming feature.
3.8
REMOTE PROGRAMMING
In order to accomplish remote programming, a security code must be
programmed. To do this, enter # 7 0, followed by four digits of choice,
which will become the security code. The only four digits that cannot be
used as a security code are 0000.
EXAMPLE: Enter # 7 0 5 5 5 1 and the phone will be programmed to
have a security code of 5551.
PROGRAMMING CONTINUED...
RING COUNT
0
No auto-answer
1
Answer after 1st ring
2
Answer after 2nd ring
3
Answer after 3rd ring
4
Answer after 4th ring
5
Answer after 5th ring
6
Answer after 6th ring
7
Answer after 7th ring
8
Answer after 8th ring
9
Answer after 9th ring
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
ISSUE 4.0
At that time,
12
Advertisement
Table of Contents
