Weatherproof telephone with optional strobe feature (17 pages)
Summary of Contents for CEECO WPP-333-F
Page 1
WPP-333-F OR SSP-313-F-SPD2.01-650-520W-ISSUE4.0 SERVICE MANUAL MODEL WPP-333-F WEATHERPROOF TELEPHONE HOB-333-F WEATHER RESISTANT TELEPHONE SSP-313-F STAINLESS STEEL PANEL TELEPHONE EQUIPED WITH SPD2.01 SOFTWARE Serving the Telephone Industry Since 1930 Communication Equipment 519 W South Park Street & Engineering Company Okeechobee, FL 34972...
ISSUE 4.0 IMPORTANT INFORMATION CUSTOMER Please fill in before you continue. The following information is necessary when calling CEECO for assistance. MODEL NUMBER MODEL WPP-333-F, HOB-331-F OR SSP-313-F EQUIPPED WITH SPD2.01 FIRMWARE SERIAL NUMBER DATE MANUFACTURED LOCATION INSTALLED For us to better serve you, please have this information available when calling for technical support.
GENERAL DESCRIPTION The CEECO Model SSP-313-F, WPP 333-F Weatherproof Telephone, and HOB-331-F Weather Resistant Telephone is a microprocessor-based coinless telephone designed to deter fraud from hand held tone dialers, hookswitch dialing and other fraudulent attempts. The transmitter can be muted during periods of dial tone preventing the use of hand held dialers.
Locations #00 - #92 are the repertory dialing memory locations. Log the numbers programmed into Section 3.0 Programming Tables. When programming is complete, move the blue mini-jumpers back to the "OFF" position and hang up the phone (“on-hook condition). CEECO Communication Equipment & Engineering Company PROPRIETARY...
Never install telephone jacks in west locations unless the jack is specifically designed for wet locations. Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface Use caution when installing or modifying telephone lines. CEECO Communication Equipment & Engineering Company PROPRIETARY...
Plug the modular line cord from the cover assembly into the RJ11C terminal block. 6.10 Dress the line cable away from the security screws. Install the faceplate into the housing and secure it by tightening the security screws. CEECO Communication Equipment & Engineering Company PROPRIETARY...
2. PROBLEM: DIAL TONE IS DISTORTED POSSIBLE CAUSE: Network cable assembly Hookswitch assembly MCRK-2 card Network Handset 3. PROBLEM: TRANSMITTER DOES NOT TURN ON POSSIBLE CAUSE: Handset MCRK-2 card Network cable assembly Network CEECO Communication Equipment & Engineering Company PROPRIETARY...
MCRK-2 card 5. PROBLEM: LOOSES MEMORY CONTENTS AFTER EXTENDED PERIODS OF NO USE. POSSIBLE CAUSE: Lithium battery 6. PROBLEM: PHONE CANNOT BE PROGRAMMED POSSIBLE CAUSE: Programming switch MCRK-2 card Keypad Keypad cable assembly CEECO Communication Equipment & Engineering Company PROPRIETARY...
Page 13
SSP Model - 4 Holes spaced 10 3/4” x 6.5” WEIGHT: WPP Model - 17 lbs. HOB Model - 10 lbs. SSP Model - 5 lbs. MEMORY RETENTION: Lithium Battery - Long Life TYPE JACK: RJ11C FCC REGISTRATION: BW88T7-13823-TE-T UL REGISTRATION: 60F5 CEECO Communication Equipment & Engineering Company PROPRIETARY...
Page 14
QUANTITY PART NUMBER DESCRIPTION 705-110 Keypad 700-008 Keypad cable 650-520W MCRK-2 PC board. 301-004-18 Handset with armored cord for WPP-333-F 301-004-32 Handset with armored cord For HOB-333-F and SSP-313-F 301-009 Network 301-581 Tongue & bracket assembly 301-588 Hookswitch cradle 301-570...
FCC registration number and ringer equivalence number. These numbers are listed in section 9.00. The FCC further requires that you notify your local telephone company when permanently disconnecting this telephone. CEECO Communication Equipment & Engineering Company PROPRIETARY...
12.3 NON-WARRANTY REPAIR CEECO will repair equipment out of warranty for a set charge plus parts. The customer must pay the shipping costs both directions. 12.4 RETURN FOR CREDIT Material may be returned for credit only with prior approval. Material authorized for return is subject to a 20% restocking charge based on the manufacturer’s list price.
This warranty is limited to the value of material only. CEECO will repair or replace any unit during this period if found to be defective for reasons other than abuse and improper use or improper installation.
POSITION BEFORE GOING OFF HOOK When programming is completed, move the mini jumpers to the OFF position. NOTE: Do not leave the mini jumpers in the ON position, this will decrease battery life. CEECO Communication Equipment & Engineering Company PROPRIETARY...
Need help?
Do you have a question about the WPP-333-F and is the answer not in the manual?
Questions and answers