Related Manuals for Extron electronics CVC 300
Summary of Contents for Extron electronics CVC 300
-
Page 1: Installation Guide
Installation Guide CVC 300 Component Video and HDTV to RGB Converter 68-1541-01 Rev. B 12 08... -
Page 2: Ul Rack Mounting Guidelines
NTSC/PAL video. Mounting The 1U high, quarter rack width, CVC 300 converter can be mounted to a rack, under a desk or tabletop, or on a projector bracket. It can be rack mounted using one-quarter of a 1U Universal Rack Shelf, RSU 129 (part #60-190-01) or 1U Basic Rack Shelf, RSB 129 (part #60-604-01). -
Page 3: Mounting Instructions
Remove the feet from the CVC, if they were previously installed. QuarterRackStandardShelf Mount the CVC 300 on the rack shelf, using two 4-40 x 3/16" screws in opposite corners (under the shelf) to secure the converter to the shelf (see below). - Page 4 BNC connectors. Connect the display as shown below. H/HV RGBHV Video H/HV RGBS Video Power LED — Green when power is applied and an active video input is detected. Amber if power is available but no input signal is present. CVC 300 • Cable Connection...
- Page 5 Position A: RGsB HD 720p, 1080i, 1080p RGBS Position B: Betacam 50 480i, 576i RGBS Position C: Betacam 60 480i, 576i RGBS D, E and F Reserved for future use Input Format Table (Rotary Switch) CVC 300 • Rate Selection...
-
Page 6: Power Supply Wiring
As an alternative, an Extron PS 123 Universal 12 VDC Power Supply, part #60-814-01, can power multiple Extron 12 VDC devices using only one AC power connector. Insert the wired plug into the power connector on the rear panel, then connect AC power. CVC 300 • Power Supply Wiring... -
Page 7: Specifications
Input level ........0.3 V to 1.0 Vp-p (sync + video) Output level ........0.0 V to 5.0 Vp-p Input impedance ......75 ohms (on Y or Gs connector) Output impedance ......75 ohms (on H/HV and V connectors) CVC 300 • Specifications... -
Page 8: Regulatory Compliance
Specifications (Cont’d) General External power supply ....100 VAC to 240 VAC, 50-60 Hz, external; to 12 VDC, 2 A, regulated Power input requirements ... 12 VDC, 1.0 A Temperature/humidity ....Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +104 °F (0 to +40 °C) / 10% to 90%, noncondensing...
Need help?
Do you have a question about the CVC 300 and is the answer not in the manual?
Questions and answers