Network Configuration (Optional) - Fujitsu PRIMERGY TX100 S2 Core Edition Operating Manual

Installation and operation
Ê Log out and log in again for the new language settings to take effect.
5.2.4.2

Network configuration (optional)

If your server is already successfully operating in the destined network with a
DHCP assigned IP address, no further configuration steps are required. Please
proceed to section "Providing computer name and domain" on page
If your server has been connected to a client computer outside the destination
network for configuration purposes, you will have to configure your TCP/IP
network settings to match the destination network.
To enable DHCP, assign a static IP address or change other TCP/IP settings,
follow these steps:
Ê Under Provide Computer Information, click Configure Networking.
I
If the Initial Configuration Tasks pane is not available, proceed as
follows:
Ê Open Network Connections by clicking the Start button, and then
clicking Control Panel.
Ê In the search box, type adapter, and then, under Network and
Sharing Center, click View network connections.
Ê Right-click the connection that you want to change, and then click Properties.
If you're prompted for an administrator password or confirmation, enter the
password or provide confirmation.
Ê In the Networking tab under This connection uses the following items, click either
Internet Protocol Version 4 (TCP/IPv4) or Internet Protocol Version 6 (TCP/IPv6),
and then click Properties.
Ê Configure IP settings to match your destination network:
I
Please note that by changing the IP address, the Remote Desktop
connection will be interrupted and the remote window will freeze.
Close the window and re-establish the Remote Desktop connection
as described in
connection" on page
Make sure you use your new IP address instead of the default values
(see section "Connecting to your server" on page
configuration changes.
52
section "Step 3: Establishing a Remote Desktop
48.
Operating Manual
54.
48) if you made
TX100 S2 Core Edition