Module Replacement - Siemens SIMATIC S7-300 Hardware And Installation Manual

10.4 Module replacement

Rules for Installation and Wiring
The table below draws your attention to points to follow when wiring, installing or
removing of S7-300 modules.
Rules governing
Blade width of screwdriver
Tightening torque
•
Attaching modules to the rail
•
Connecting cables
POWER OFF when replacing the
...
S7-300 operating mode when
replacing ...
Load voltage OFF when
replacing the ...
Initial Situation
The module you want to replace is installed and wired. You want to install a new
module of the same type.
Warning
Disturbances can corrupt data if you insert or remove S7-300 modules while data
is transferred via MPI.
Do not replace S7-300 modules while there is data traffic on the MPI.
If you are not certain whether or not data transfer is active on the MPI, unplug the
connector on the MPI before you replace the module.
S7-300 Programmable Controller Hardware and Installation
A5E00105492-02
... Power supply
3.5 mm (cylindrical model)
from 0.8 N/m to 1.1 N/m
from 0.5 N/m to 0.8 N/m
Yes
–
Yes
Maintenance
... CPU ... SM/FM/CP
from 0.8 N/m to
1.1 N/m
–
Yes
STOP
Yes
10-5