Programming The Dispenser; Programming Switches - Bunn IMIX-3S+ Installation & Operating Manual

The following function screens are in order of appearance. Each screen will have instructions on how to
access, and the procedures to program the various functions of the dispenser. To enable programming, place
the "NORMAL/PROGRAM/RINSE" switch in the "PROGRAM" position.
To exit the programming mode at any time, press and release the exit (center) pad located on the front
switch panel. The display will return to the PROGRAM HOME SCREEN.
If none of the five programming switches are pressed within 90 seconds during the setup of the dispenser,
the programming of the function screen that is being set will be exited and the display will return to the PRO-
GRAM HOME SCREEN.

PROGRAMMING SWITCHES

Using the menu-driven display (MAIN SCREEN) on the front of dispenser, the operator has the ability to alter
or modify various functions of the dispenser. This allows for precise dispensing of various flavors of powdered
products.
Programming of dispenser is achieved by entering a certain function, then, by use of programming switch-
es, the operator can customize the dispensing process to their specifications.
To access the programming mode, and to scroll through different function screens, the programming
switches shown are used. There are five switches that will be used for setup of the dispenser.
NORMAL/PROGRAM/RINSE switch:
NORMAL: Allows all dispenser functions. Must be in this position for dis-
pensing.
PROGRAM: Allows access to program menus using touch pad and LCD
screen.
RINSE: Pressing dispense button on front door will dispense dilution water
and power whipper motor for ten seconds.

PROGRAMMING THE DISPENSER

IMPORTANT PROGRAMMING NOTES - READ CAREFULLY
E D
A. Enter program mode and advance to next menu
B. Increment display value positive
C. Exit program mode
D. Increment display value negative
E. Return to previous menu
C B A
27
P4369
P4368
52384.0 101116