General Cleaning; Daily: Parts Washing; Weekly: Parts Washing - Bunn IMIX-3S+ Installation & Operating Manual

GENERAL CLEANING

The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all surfaces on
Bunn-O-Matic equipment.
Exterior Surfaces:
• Do not use any abrasive materials.
• Use a soft, dry cloth to wipe down the exterior surfaces of the dispenser to maintain the luster of the
stainless steel finish.
• Wash the stainless steel exterior surfaces of the dispenser with warm, soapy water. Rinse with warm,
clear water. If the water is hard, wipe the dispenser dry with a soft cloth to prevent water spotting.
• Stainless steel polish may be used if it is sprayed on a cloth before the cloth is used to wipe down the
exterior surfaces of the dispenser.

DAILY: PARTS WASHING

1. Remove and wash the drip tray and drip tray cover in a mild detergent solution. Rinse thoroughly.
2. Wipe the lower front panel, door, and cabinet with a clean damp cloth.

WEEKLY: PARTS WASHING

1. Remove the elbows and slide gates from all hoppers. Disconnect the elbows from the outlets of both mixing
chambers.
2. Remove the powder mixing chambers, steam traps, frothers and mixing chamber bases.
3. Remove the dispense hoses from the dispense nozzle assembly.
4. Clean all parts removed in warm soapy water. Use Bunn P/N 11685.0000 cleaning brush provided to clean
bores and orifices. Rinse in cold water.
5. Prepare one-gallon (3.8 liter) of sanitizing solution with at least 100 ppm of available chlorine in 120°F
(48.9°C) water. Soak all cleaned parts in sanitizing solution for 5 minutes, then allow to air dry.
6. Rinse cleaning brush, dip in sanitizing solution, and brush the bore of both dispense nozzles
NOTE: Repeat this procedure for each nozzle separately.
7. When reassembling parts, be sure to align arrow on frother disk with flat on whipper motor shaft, and rotate
tab on whipper base clock wise to the vertical position to lock mixing chamber.
11
52384.0 101116