Bunn IMIX-3S+ Installation & Operating Manual page 9

Filling Soluble Hoppers
1. Remove packing material from on top of the powder hoppers.
2. Remove powder hoppers by lifting the front of the powder
hopper until the peg on the bottom of the hopper clears the hole in
the mounting plate (see Figure 1). Then pull the hopper forward to
remove.
3. Set the hoppers on the counter, and push the slide gates on the
front of the discharge chutes inward (see Figure 2) to close the
gates.
4. Remove hopper lids and fill the hoppers with appropriate soluble
products. Default menu is milk product left hopper, chocolate is
center hopper, and vanilla is right hopper. Replace hopper lids.
5. Reinstall hoppers back into machine, make sure peg on bottom of
hopper drops into locating hole on hopper platform.
6. After hoppers are installed, discharge chutes must be rotated as
shown in Figure 3.
9
Figure 1
Figure 2
Figure 3
52384.0 101116