Bunn IMIX-3S+ Installation & Operating Manual page 18

Weekly: Parts Washing and Sanitizing
1. Remove elbows from 2. Remove elbows from
all hoppers.
6. Rotate tab on mix-
7. Remove
ing chamber base
further counter clock
wise, and remover
from shaft by pulling
straight out.
NOTE: Insure O-ring and
shaft seal are in place
during re-assembly.
11. When reassembling
parts, be sure to align
arrow on frother disk
with flat on whipper
motor shaft, and ro-
tate tab on whipper
base clock wise to
the vertical position
to lock mixing cham-
ber.
3. Rotate tab at bottom
right & left mixing
chambers, twisting
slightly to help re-
lease.
dispense
8. Clean all parts re-
hoses from dispense
nozzle assembly.
4. Remove
chambers by pulling
of mixing chamber
bases counter clock straight out.
wise to release base.
9. Prepare
(3.8 liter) of sanitiz-
moved in warm soapy
ing solution with at
water. Use Bunn P/N
least 100 ppm of
11685.0000 clean-
available chlorine in
ing brush provided
120°F (48.9°C) wa-
to clean bores and
ter. Soak all cleaned
orifices. Rinse in cold
parts in sanitizing so-
water.
lution for 5 minutes,
then allow to air dry.
18
mixing
5. Remove right frother
disk from shaft by
pulling straight out.
one-gallon 10. Rinse cleaning brush,
dip in sanitizing solu-
tion, and brush the
bore of both dispense
nozzles.
NOTE: Repeat this pro-
cedure for each nozzle
separately.
52384.0 101116