Mounting Methods; Figure 2-4 How To Remove Knockouts - Honeywell DR4500A Product Manual

2.4 Mounting Methods

Introduction
There are several methods available for mounting your recorder. They are:

Flush in Panel (new panel cutout)

Flush in Panel (using an existing panel cutout)

using universal filler plate kit

using cutout made for Kent Model 105M

Flush in Panel for recorders with NEMA4 Door

On a 2-inch Pipe

On Surface (of panel or wall)
Procedures for each method follow. Choose the one that meets your mounting requirements. Use the
associated dimension drawings for reference.
How to remove knockouts for conduits
Before you mount the recorder, remove the appropriate "knockouts" in the bottom and/or sides of the
recorder case for wire entry via 1/2" (12.7mm) conduits. Refer to Figure 2-4 for knockout locations.
ATTENTION
The knockouts are really plugs that you just have to push out to remove.
Release M DR4500A Classic Series Circular Chart Recorder With or Without Control Product Manual
April 2017
Side View

Figure 2-4 How to remove knockouts

Installation - Mounting Methods
Bottom View
2 1 4 0 5
17