Lockout Parameters Set Up Group; Dr4500A Classic Series Circular Chart Recorder With Or Without Control Product Manual Release M; Table 4-14 Lockout Group Definitions - Honeywell DR4500A Product Manual

Configuration Parameter Definitions

Lockout Parameters Set Up Group

4.14 Lockout Parameters Set Up Group
Introduction
These are the parameters that you will set to lockout any unauthorized changes to the recorder's
configuration and calibration prompts.
ATTENTION
Configuration can also be locked using S1 switch on the main printed circuit board. Refer to
Subsection 2.9 – Configuration Lockout Switch. The chart plate can be sealed using a lead
seal to provide a positive indication that the electronics and configuration lockout switch may
have been accessed.
Set this group last
Because this group contains functions that have to do with security and lockout, we recommend that you
configure this group last, after all the other configuration data has been loaded.
Lockout group prompts
Table 4-14 lists all the function prompts in the Lockout set up group and their definitions.
Lower Display
Prompt Range of Setting or Selection
LOCKOUT
NONE
CALIB
+CONF
MAX
114 DR4500A Classic Series Circular Chart Recorder With or Without Control Product Manual

Table 4-14 Lockout group definitions

Upper Display Parameter Definition
LOCKOUT applies to one of the functional groups:
Configuration, Calibration, Tuning, Adaptive Tune. DO
NOT CONFIGURE UNTIL ALL CONFIGURATION IS
COMPLETE.
No Lockout – all groups read/write.
CALIB – All are available for read/write except for the
Calibration group.
+CONF – Tuning, SP Ramp and program groups are
read/write. All other groups are read only. Calibration
group is not available.
MAX – Calibration group not available. All other groups
are Read-only.
ATTENTION
Do not leave in "NONE" Lockout.
Release M
April 2017