Sp Ramp Set Up Groups; Table 3-9 Sp Ramp 1 Or 2 Group Function Prompts - Honeywell DR4500A Product Manual

Configuration

SP Ramp Set Up Groups

3.12 SP Ramp Set Up Groups
The Setpoint Ramp 1 or 2 Set Up groups let you configure two setpoint ramps. Each group (SP RAMP1
and SP RAMP 2) can be configured one of three ways: ramp, rate, or setpoint program.
Setpoint Ramp
Setpoint will ramp between the current local setpoint and a final setpoint over a time interval (SP RAMP).
Setpoint Rate
The Setpoint Ramp Set Up group also contains the function parameters that let you configure a specific
ramp rate up and ramp rate down (SP RATE). These rates are used when the local setpoint is manually
changed.
Setpoint Program
Also included under this group are prompts for configuring a Setpoint program (SP PROG). The prompts
and instructions for Setpoint programming are presented in the Section 6 - Setpoint Ramp/Soak
Programming Option.
Function prompts
Table 3-9 lists all the function prompts in the SP RAMP 1 or SP RAMP 2 Set Up group. Configure each
ramp separately. When you enable the ramp type (SP RAMP, SP RATE, SP PROG) the other two types
are hidden from the display.
Function Prompt
Lower Display
SP RAMP* Single Setpoint Ramp
Selection
TIME MIN Single Setpoint Ramp Time
FINAL SP Single Setpoint Ramp Final
Setpoint
SP RATE*
Setpoint Rate
EU/HR UP Rate up value (SP Rate
enabled)
EU/HR DN
Rate down value (SP Rate
enabled)
SP PROG* Setpoint Programming
(Refer to Section 6)
*Only one of these can be enabled at a time.
70 DR4500A Classic Series Circular Chart Recorder With or Without Control Product Manual

Table 3-9 SP Ramp 1 or 2 group function prompts

Function Name Selections or Range of Setting
Upper Display
DISABL
ENABLE
0 to 255 minutes
Enter a value within the setpoint limits
DISABL
ENABLE
0 to 9999
in units per hour
0 to 9999
in units per hour
DISABL
ENABLE
Factory
Setting
DISABL
0
100.0
DISABL
0
0
DISABL
Release M
April 2017