Disk Assignments - IBM System Storage N3700 Hardware And Service Manual

N series
Table of Contents

Advertisement

Disk assignments

In the N3700 storage system, each node must have ownership of at least one SES
disk in each disk shelf in the system. For example, in a single disk shelf system,
Node A could own the disk in bay 0, and Node B would then own the disk in bay 1.
In a factory-configured system, one node has ownership of one SES bay disk and
the other node owns the second SES bay disk. In addition, each node has
ownership of one parity disk and one spare disk. Node B owns disks 0b.16, 0b.18,
and 0b.20, and Node A owns disks 0b.17, 0b.19, and 0b.21. The balance of the
disks are unowned.
If you add storage to your N3700 storage system, it arrives with unowned disks.
You must assign ownership of the SES disks to the appropriate node.
Notes:
1. Always install the hard disk drives sequentially in adjacent drive bays in the
2. You can change the disk ownership pattern after initial setup. For information
Figure 3 on page 13 identifies the SES bays in the N3700 storage system or in an
expansion unit disk shelf.
Note: N3700 systems with the load board feature must contain no Fibre Channel
12
IBM System Storage N series: N3700 Hardware and Service Guide
Table 6. System setup worksheet (continued)
Setup parameters
Flow control (none, receive,
send, full)-e0b:
Enable jumbo frames?-first
interface, e0a:
Enable jumbo
frames?-second interface,
e0b:
IP address or name of default
gateway:
IP address or name of
administration host: (Leave
blank for root access to /etc
from any NFS client)
Where is filer located? (Text
string)
Do you want to run DNS
resolver?
Do you want to run NIS
client?
N3700, starting with drive bay 0 and continuing from right to left.
about how to change disk ownership, see the IBM System Storage N series
Data ONTAP Storage Management Guide for your version of Data ONTAP.
disks. If the load feature is ordered for your N3700, all disk drive bays except
bays 0 and 1 contain disk drive blanks. Bays 0 and 1 contain N3700 load
boards.
Node B
Node A (not present in
N3700 2863–A10)

Advertisement

Table of Contents
loading

Table of Contents