Setup Script Questions - IBM System Storage N3700 Hardware And Service Manual

N series

Table of Contents

12. Complete the booting procedure according to your system configuration:

Setup script questions

The following example lists the setup script questions and answers you see when

you boot your system for the first time. Script feedback is in italics:

Please enter the new hostname []: bu-165

Do you want to configure virtual network interfaces? [n]: n

Please enter the IP address for Network Interface e0a []: 172.22.6.165

Please enter the netmask for Network Interface e0a []: 255.255.255.0

Should interface e0a take over a partner IP address during failover? [n]: y

The clustered failover software is not yet licensed. To enable network failover, you

should run the license command for clustered failover.

Please enter the IP address or interface name to be taken over by e0a []:

172.22.6.164

Please enter the media type for e0a {100tx-fd, tp-fd, 100tx, tp, auto

(10/100/1000)} [auto]:

Please enter the flow control for e0a {none, receive, send, full} [full]:

Do you want e0a to support jumbo frames? [n]:

Please enter the IP address for Network Interface e0b []:

Should interface e0b take over a partner IP address during failover? [n]:

Please enter the name or IP address of the default gateway []: 172.22.6.1

The administration host is given root access to the filer's /etc files for system

administration. To allow /etc root access to all NFS clients, enter RETURN below.

Please enter the name or IP address of the administration host:

IBM System Storage N series: N3700 Hardware and Service Guide

c. Give back the node by entering the following command:

cf giveback

d. Check the status of the active-active (clustered) configuration using the cf

status command.

e. Repeat steps a through c for the next node.

v If you are setting up a NAS active-active (clustered) configuration, go to the

IBM System Storage N series Data ONTAP Software Setup Guide for your

version of Data ONTAP for advanced system setup.

v If you are setting up a SAN active-active (clustered) configuration with

iSCSI, complete the following steps:

a. License iSCSI services.

b. Set up LUNs, as described in the IBM System Storage N series Data

ONTAP Block Access Management Guide for your version of Data

ONTAP.

Table of Contents