Raising The Power Supply Handle - IBM System Storage N3700 Hardware And Service Manual

Figure 16. Raising the power supply handle
4. Lift up the clip lock and plug the power cord into the power receptacle and
fasten it with the clip lock.
5. Plug the other end of the power cord into a grounded AC power source.
6. Turn on the power switch and confirm proper operation by checking the power
supply LEDs. See "Monitoring the power supply" on page 21.
7. After turning on your system, run diagnostics. See the IBM System Storage N
series Diagnostics Guide for more information.
Chapter 5. Replacing N3700 storage system devices
41