Vesa Wall-Mount Kit Installation - EBN Technology X-PPC 710 User Manual

B. Power Supply Configuration
Power up the XPPC710 and hit the DEL key to enter the BIOS. When the BIOS screen
appears use the TAB key to select Advanced. Use the arrow keys to select Super IO
Configuration then type ENTER. The screen below will appear. Use the arrow keys to
select Serial Port 6 RI/12V depending on what port the customer display is connected
to. Select 12V to enable power to the correct COM port. Type F10 to save the settings
and exit the BIOS setup.
Caution: Never enable the 12 V without the customer display attached and be sure to
disable the 12 V before removing the customer display.
NOTE: The figure above is for reference only; it is possible that the actual screen on
your device does not agree with it.

1.4. VESA Wall-mount Kit Installation

1. Install the device bracket.
2. Put the XPPC 710 onto the wall bracket which is preinstalled on the wall.
3. Tighten the screw.
Chapter 1
10