Planet WSG-401 User Manual page 7

LEDs Indication
LED State
Power Off
Green
WAN Green
Green (Blinking) Data is in transmitting and receiving on WAN port.
LAN (1-4) Green
Green (Blinking) 10/100Mbps traffic is traversing the port.
Off
Green
Wireless
Green (Blinking) The Wireless connection is active.
Off
Status
Green (Solid)
Green (Blinking) During firmware upgrades, this status LED will blink.
1-3-2 Rear Panel
Rear panel of PLANET WSG-401 is shown below.
1. Power Jack:
Used to connect the external power supply with PLANET WSG-401 device.
2. LAN Port:
WSG-401 supports four auto-sensing RJ-45 ports and all ports can be auto-switched to MDI-II
connections. The LAN ports used for linking hosts or other networking device.
3. WAN Port:
One RJ-45 port used for linking xDSL or Cable Mode
4. Device Port
Used to connect the Thermal Printer WSG-ACG.
1-3-3 Left Side Panel
The left side panel of the WSG-401 is shown below.
WSG-401 User Manual
Description
WSG-401 is not receiving electrical power.
WSG-401 is receiving electrical power.
The WAN port is used to connect your xDSL or Cable modem.
A port has established a valid 10/100Mbps network connection.
Port has not established any network connection.
The WSG-401 has established a valid wireless connection.
The WSG-401 status is defective.
WSG-401 status is complete.
Figure 1-3 WSG-401 Rear Panel
7